Hawkeye Torque Anchor Manuel d'utilisateur télécharger pdf (Page 1)

This document contains the recommended procedures to install and refurbish the Dynamic Torque Anchor.

A.) Installation - Initial Function Test

B.) Installation

C.) Disengage

D.) Service & Refurbishment

Installation and Refurbishment Instructions

Dynamic Torque Anchor

Torque Anchor Installation / Refurb Instructions, April 2014

Figure 1 Figure 2 Figure 3

Figure 4

1.) Run the Torque Anchor, box end up, into the first joint of casing (Fig.

2.) Set the Torque Anchor with 300 ft-lb of right-hand torque (Fig. 2)

3.) Examine the contact points to ensure proper engagement of the an-

chor blocks in the ID of the casing.

4.) Once satisfied, relax the right-hand torque (Fig. 3) and the anchor is

ready to be run to the desired depth.

1.) Run the torque anchor to the desired depth. The anchor must be in-

stalled box end up and below the pump (Fig. 1).

2.) At the desired depth, apply approximately 300 ft-lb of right-hand

torque (Fig. 2) on the anchor to engage the anchor blocks to the cas-

ing wall.

3.) The setting torque can be locked in and pump operation started.

Note: To avoid disengaging the anchor when starting or stopping the

pump, pre-torque the tubing string.

1.) Stop pump.

2.) Relax setting torque (Fig. 3).

1.) Disassemble the torque an-

chor to its individual compo-

nents (Fig. 4):

► Body (A)

► Anchor Blocks (B)

► Retaining Ring (C)

► Spring (D) *

► Hex Socket Screw (E) *

* Do not reuse these components.

2.) Clean the body, anchor

blocks and retaining rings

using varsol, sand blasting or

other means to provide a

clean part for inspection

3.) Inspect the parts for cracks,

deformations from over-

torque and corrosion. Dam-

aged parts should not be

reused. Use discretion when

examining the anchor blocks.

If there is any doubt with con-

tinued use, replace the an-

chor blocks.

4.) Reassemble the Torque An-

chor using the Assembly Pro-

cedure.

► 1/4” Allen Key

► Torque Wrench

► Solvent / Cleaning Solution

► Sand Blaster

► Heavy Duty rubber band

► Band clamp / Cinch Rope

Contents Refurb / Reassembly Tools

Parts Required

A.) Installation - Initial Function Test

B.) Installation

C.) Disengage

D.) Service and Refurbishment

E.) Reassembly

QTY Part

► 1 Torque Anchor Refurb. Kit for your size of anchor.

300 FT-LB

1 2

Résumé du contenu

Page 1 - Dynamic Torque Anchor

This document contains the recommended procedures to install and refurbish the Dynamic Torque Anchor.A.) Installation - Initial Function TestB.) Insta

Page 2 - E.) Reassembly

E.) Reassembly1.) Stand the anchor body up-side down (pin end up) andinstall the retaining ring, andsecure into place using thehex-socket cap screws.T

Commentaires sur ces manuels

Pas de commentaire

Hawkeye Torque Anchor Manuel d'utilisateur Page 1

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Capteurs Hawkeye Torque Anchor. Hawkeye Torque Anchor User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels